We try to stick to the 0805 parts because they’re still big enough to solder by hand. But [Scott] shows us that it doesn’t take too many special tools to reflow fine-pitch components at home. In this ...

Need to do some SMD soldering? No tools? No problem! Here’s a creative method that could be a handy tool to add to your belt: SMD soldering using hot sand. [Oliver Krohn] recently released this little ...

Extra soldering tools are not necessary to solder/unsolder and re-work surface mount technology (SMT) components 6''-14'' in size. 【INFRARED SOLDERING TECHNOLOGY】Technician focused infrared heat is ...

SMD soldering – At first, I tinned all the circuit board pads for the SMD chips before trying to mount them. That was a mistake. With both pads for chip tinned, heating up one end of the chip caused ...

In the 1800s and early 1900s soldering irons were still heated by flame. The large copper tips on the irons were slow to heat and would at best store heat for only a few minutes. It was not uncommon ...

The result is that the entire board is much denser, and comments can be installed on both sides of the PC board, as seen in Figure 2 . Since the board does not require drilling for component leads ...